Lancia Motor Club Forum Banner
28 March, 2024, 09:35:44 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Need to contact the Forum Administrator? e-mail forum.admin@lanciamc.co.uk, for Database Administrator e-mail database.admin@lanciamc.co.uk      -      Copy deadline for Viva Lancia is 12th of each month.      -      For Events e-mail events@lanciamc.co.uk      -      To Join the club go to http://www.lanciamc.co.uk/join.htm
 
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
  Print  
Author Topic: Rear Axle Oil Seals  (Read 3623 times)
0 Members and 1 Guest are viewing this topic.
Augustacab
Member
**
Posts: 11



« on: 17 October, 2017, 03:08:55 PM »

I am starting the process of replacing the rear oil seals on my Augusta - I have seen the notes in the Newsletters so am happy about the new oil seals - but how do you draw out the half shafts after you have removed the bearing retaining nut and out seal? Is there anything else I need to know?
Thanks
Logged
JohnMillham
Permanent resident
**
Posts: 1045



« Reply #1 on: 19 October, 2017, 01:45:46 PM »

I am starting the process of replacing the rear oil seals on my Augusta - I have seen the notes in the Newsletters so am happy about the new oil seals - but how do you draw out the half shafts after you have removed the bearing retaining nut and out seal? Is there anything else I need to know?
Thanks
It just pulls out. You might have to make a puller if it's stuck. Or borrow mine, if I can find it. It's a simple bar with two threaded holes and a bigger hole in the centre which goes on the half shaft, under the nut.
Regards, John
Logged
Augustacab
Member
**
Posts: 11



« Reply #2 on: 27 October, 2017, 07:44:57 AM »

Many thanks John
Logged
Kari
Senior Member
*****
Posts: 187


« Reply #3 on: 13 November, 2017, 08:50:21 AM »

Hello all,
One method to pull the half shafts is, to refit the brake drum loose onto the half shaft and use the drums mass to bump out the shaft.

If you want to modify the outher seals as well, be aware that there are two different sizes for it, the early ones at 38 mm dia. the later ones at 42 mm dia. (see picture, left late, right early)

regards Karl


* 100_3832.jpg (911.71 KB, 2304x1536 - viewed 403 times.)

* 100_3833.jpg (704.66 KB, 2304x1536 - viewed 377 times.)
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2021 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines
Page created in 0.076 seconds with 20 queries.