Lancia Motor Club Forum Banner
28 October, 2021, 06:57:23 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Need to contact the Forum Administrator? e-mail, for Database Administrator e-mail      -      Copy deadline for Viva Lancia is 12th of each month.      -      For Events e-mail      -      To Join the club go to
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
Author Topic: drive shaft grease; How much?  (Read 1211 times)
0 Members and 1 Guest are viewing this topic.
Senior Member
Posts: 173

« on: 17 December, 2011, 07:28:17 PM »

Does anyone know how much (in grammes?) grease should be used to repack the inboard & outboard driveshaft joints on a Series 2?
« Reply #1 on: 18 December, 2011, 03:54:48 PM »

If I remember we used to get a small sachet of grease with the cv boot kit when we used to fit them? you don't fill it, make sure you have the joint nicely covered with quite a bit of excess over it and that will do, as long as it doesn't leak out again
Press Officer
Permanent resident
Posts: 4362

« Reply #2 on: 18 December, 2011, 04:05:05 PM »

I always pack the joint (no rasta jokes...) then put the boot on and release any pneumatic pressure with a smal screw driver up between the shaft and the boot.....


Its not the winning but taking part! or is it taking apart?
1955 Aurelia B12
1967 Flavia Vignale iniezione
1967 Fulvia 1.3HFR
1972 Fulvia 1600HF
1972 Fulvia 1600HF
1972 1600 Fulvia Sport
1979 2500 Gamma Coupe
1988 Delta 1.6GTi
1998 Zeta
Pages: [1]   Go Up
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2021 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines
Page created in 0.042 seconds with 21 queries.