Lancia Motor Club

Tall order I know but I am searching for a series 1 steel bonnett in repairable  condition.
Can anybody help?
Dave

Hello Dave

The Series 1 coupé has an aluminium bonnet, with a s/s centre strip (probably gives some strengthening?).  Not impossible to weld up the holes for the strip which will then let it fit on a Series 2 car and look okay.  The aluminium ones can 'tear' around the hinge plates area, and might need attention.  Series 2 and 3 coupés have steel bonnets, but as you will know, are very prone to rot along the front due to moisture lying in the double skinned area.  Omicron do (or used to?) patch part panels for across the front.  I'm not being rude, but I would suggest that you try and find a S1 bonnet as being a much better choice than the later steel one, as well as lighter too.

Sorry, but I can't help you out with sourcing one.

Good luck, and regards - Roddy

Hi Toddy,
Mine is steel. Apparently  some were steel and I think the later series 1s were aluminium. I would really prefer aluminium.  I have been offered one to my great surprise at a cost that was even more shocking. Have you seen any bonnets  being offered in the past and noticed the price, I need to know a figure to guide me through. I have no clues on the current  price.

Predictive problem there Roddy, sorry .

I know it's not what you were asking for but I think Omicron also do fibreglass bonnet and boot lids. Lighter(?) and rustproof too if nothing else comes up.

Thanks  very much.
Came across a few today, ranging from 500 to 2300 sterling. I shall probably go with Omicron who can repair existing one and I know that fits.