Lancia Motor Club

Model Technical and Interest => Fulvia => Topic started by: waterboy on 15 March, 2012, 07:21:44 AM



Title: Numberplate lighting
Post by: waterboy on 15 March, 2012, 07:21:44 AM
Hi all, after much searching i have finally obtained a pair of Fiat rear lights to enable me to move my number plate to its original position. If anyone has got a bumper-less Fulvia and a tape handy, i am after the centres please.
Cheers,
Simon.


Title: Re: Numberplate lighting
Post by: stanley sweet on 15 March, 2012, 10:12:19 AM
My Fulvia is bumperless. What centres are you after?


Title: Re: Numberplate lighting
Post by: waterboy on 15 March, 2012, 10:35:08 AM
Hi, I am after the distance between the two number plate lights as i have not received my number plate yet and impatience is my middle name. The drill is ready to go so to speak. From looking at internet photos of bumper-less models it roughly looks about an inch gap either side of the plate.
Cheers,
Simon.


Title: Re: Numberplate lighting
Post by: stanley sweet on 15 March, 2012, 12:44:49 PM
Ah - in that case I'd better leave it to someone else. Mine is a 1.3S and was modified with just a single number plate light. You sound like you need the proper measurements from a 1600HF.


Title: Re: Numberplate lighting
Post by: richardgcs on 15 March, 2012, 09:16:57 PM
have measured the fixing hole centres on my HF rear lights at 33.5mm


Title: Re: Numberplate lighting
Post by: richardgcs on 15 March, 2012, 09:38:13 PM
make that cm


Title: Re: Numberplate lighting
Post by: waterboy on 16 March, 2012, 07:59:27 AM
Cheers for that.