Lancia Motor Club Forum Banner
20 July, 2019, 06:13:58 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Calendar Register  
Pages: 1 ... 38 39 40 41 42 [43]   Go Down
  Print  
Author Topic: Story so far series 1 resto  (Read 80287 times)
0 Members and 1 Guest are viewing this topic.
lancianut666
Rebel Poster
*
Offline Offline

Posts: 984


Slow but rough


« Reply #630 on: 14 May, 2019, 05:30:32 PM »

Hi all
Followed the procedure again and this time I managed to stop the sprockets from falling off so progress. Tried checking the firing order/valve sequence and if I do 1-3-4-2 I can get the rotor arm in the right position with both valves for each cylinder closed so should start...seems I was here before last year when I put the engine together. I have tried following the valve open shut sequence but it seems all to pot so I might put the protractor on the flywheel so I can turn the engine from the front. I think I need to get my mate Terry over to give me another pair of eyes on what is going on.
Clarkey
Logged

Fulvia Coupe S2 Flavia Coupe 1967 1.8 Kugelfischer Prisma 1.6 carb Y10 Fila Y10 Touring Dedra 1.8 Dedra 2.0 Turbo Appia S1
lancianut666
Rebel Poster
*
Offline Offline

Posts: 984


Slow but rough


« Reply #631 on: 15 May, 2019, 11:31:33 AM »

Had a think and decided to check each valve starting to open based on the info in the repair guide so inlet opens at 15 deg BTDC etc...with this method I could feel the tappet clearance close down the nearer you got to the setting so I checked all 8 valves for opening and they seem to do it where they should be so I'll put it all back together and test it out tomorrow.
Clarkey
Logged

Fulvia Coupe S2 Flavia Coupe 1967 1.8 Kugelfischer Prisma 1.6 carb Y10 Fila Y10 Touring Dedra 1.8 Dedra 2.0 Turbo Appia S1
lancianut666
Rebel Poster
*
Offline Offline

Posts: 984


Slow but rough


« Reply #632 on: 30 June, 2019, 03:02:46 PM »

My marking has got in the way of this as I know if I start messing about and it starts I will want it back in the car and then...and then...and then...it will be the middle of September! and no marking done.
Clarkey


* 20190630_155559.jpg (1029.5 KB, 2048x1152 - viewed 13 times.)
Logged

Fulvia Coupe S2 Flavia Coupe 1967 1.8 Kugelfischer Prisma 1.6 carb Y10 Fila Y10 Touring Dedra 1.8 Dedra 2.0 Turbo Appia S1
Pages: 1 ... 38 39 40 41 42 [43]   Go Up
  Print  
 
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2018 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines