Lancia Motor Club Forum Banner
07 April, 2020, 09:13:34 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
Author Topic: Upper Ball Joint - Dust cover  (Read 804 times)
0 Members and 1 Guest are viewing this topic.
Angle Grinder
Offline Offline

Posts: 395

« on: 18 November, 2009, 12:35:59 PM »

Whilst cleaning out my wheel arches, I noticed that I have a tear in the rubber boot that protects the upper ball joint on my Flavia Coupe's Suspension.

Its a 1967 car and I think the boot is meant to have a small aperture in it!?

I seem to recall reading that these rubber boots are the same as some that are fitted to Jaguars, but can't find where I read about this.  Undecided

Has anyone any ideas about a substitute boot that would fit or do you have to replace the whole ball-joint?


Current Cars: 1994 2.0 VIS Thema Station Wagon, 1967 Flavia 1.8 PF Coupe.

Previous cars:
1983 Prisma 1600
1991 Thema 16v i.e. SE
1988 Thema 8v Turbo
1992 Thema 16v i.e.
1983 Gamma Coupe (manual)
1993 Thema VIS
1994 Thema VIS LE
1990 Thema 2.8
Rebel Poster
Offline Offline

Posts: 980

« Reply #1 on: 18 November, 2009, 01:04:25 PM »

If they are the same as Fulvias you can buy them from Omicron. I looked round a few local motor factors but I could not find any the right size. Omicron had them on the shelf.

1969 Fanalone, Mazda RX-8, Fiat Multipla
Pages: [1]   Go Up
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2018 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines