Lancia Motor Club Forum Banner
09 April, 2020, 11:43:12 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
Author Topic: Steering Box  (Read 844 times)
0 Members and 1 Guest are viewing this topic.
Nick Gramaglia
Offline Offline

Posts: 63

« on: 14 September, 2009, 04:08:55 PM »


Has anyone replaced the two oil seals in the steering box. I have removed the box from car and bought new seals, removed the 36mm nut that secures the drop arm to the splined shaft but cannot seperate the two. I bought a two leg puller but it was not strong enough for the job.Any sugestions ?

Rebel Poster
Offline Offline

Posts: 980

« Reply #1 on: 14 September, 2009, 05:32:38 PM »

Heat, cool, hammer and patience I'm afraid. A puller with a blow torch should maybe shift it. But don't be surprised if it takes a few days (seriously).

Some sources of information - and encouragement  Cheesy

1969 Fanalone, Mazda RX-8, Fiat Multipla
Offline Offline

Posts: 271

« Reply #2 on: 15 September, 2009, 11:11:17 AM »

There is a special Lancia steering box puller which significantly helps because it does not tend to slip away like other standard pullers. You may also need heat and tapping the puller as you try to separate the parts. Andrea

Andrea Nistri

Ardea S2
Appia S2
Fulvia GTE
Fulvia Sport 1.3 S
Fulvia Montecarlo
Fulvia Coupe 1.3 S
Pages: [1]   Go Up
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2018 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines