Lancia Motor Club Forum Banner
28 October, 2021, 06:54:34 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Need to contact the Forum Administrator? e-mail, for Database Administrator e-mail      -      Copy deadline for Viva Lancia is 12th of each month.      -      For Events e-mail      -      To Join the club go to
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
Author Topic: Fulvia engine height  (Read 987 times)
0 Members and 1 Guest are viewing this topic.
Senior Member
Posts: 104

« on: 21 November, 2020, 06:49:13 PM »

We have recently re-fitted the engine in my S1 Coupe using new engine mounts. I trial fitted the manifold and carbs (45 DHLA) and the bonnet would not close. Fair enough I thought but I noticed that the thermostat housing was about 5 centimetres above the top radiator outlet and looking at the engine it looked to have a pretty steep incline toward the front. I thought there might be a clearance problem with the carbs but my problem seems extreme. I have for now 'solved' the problem by cutting down the upper rubbers by quite a lot but I am not happy with having to do it. Is this anyone else has come across? Perhaps  the mounts settle after a while but not by the amount I have cut out of them. I am now left with not much more than 1 centimetre of rubber in the top mounts and worry that it is not enough.

1969 Rallye 1.3S
Posts: 52

« Reply #1 on: 21 November, 2020, 07:14:33 PM »

It seems to me you shouldn't need to cut anything to have everything fit.  They aren't going to make engine mounts that you have to then cut to get things to fit.  Something did not go back in correctly.  Do you have any pictures of the engine bay with the old mounts, even just across the top. Then you can see if it is just the front that is too high or the whole engine.  My car isn't here at the moment so I can't have a look or take any measurements.  Your best bet is to look at old pictures you hopefully have so you can compare pre and post engine mount refit.
Press Officer
Permanent resident
Posts: 4362

« Reply #2 on: 21 November, 2020, 09:00:48 PM »

My 1600 has twin dellorto 45ís and bonnet has c10mm clearance when closed.

Its not the winning but taking part! or is it taking apart?
1955 Aurelia B12
1967 Flavia Vignale iniezione
1967 Fulvia 1.3HFR
1972 Fulvia 1600HF
1972 Fulvia 1600HF
1972 1600 Fulvia Sport
1979 2500 Gamma Coupe
1988 Delta 1.6GTi
1998 Zeta
Posts: 459

B20 s.2, Appia C10 unrestored

« Reply #3 on: 22 November, 2020, 01:41:58 PM »

1600 is a wee bit taller than 1300.

B20 s.2, Appia C10 unrestored
Pages: [1]   Go Up
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2021 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines
Page created in 0.033 seconds with 21 queries.