Lancia Motor Club Forum Banner
30 September, 2020, 03:04:57 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Need to contact the Forum Administrator? e-mail forum.admin@lanciamc.co.uk, for Database Administrator e-mail database.admin@lanciamc.co.uk      -      Copy deadline for Viva Lancia is 12th of each month.      -      For Events e-mail events@lanciamc.co.uk      -      To Join the club go to http://www.lanciamc.co.uk/join.htm
 
   Home   Help Search Calendar Register  
Pages: [1]   Go Down
  Print  
Author Topic: Engine Torque settings  (Read 59 times)
0 Members and 1 Guest are viewing this topic.
rutley1
Member
*
Posts: 8


« on: 24 September, 2020, 10:09:41 AM »

Can anyone tell me the correct torque settings for the engine re-assembly please ?  This should include big ends and main bearing bolts.  Many thanks in anticipation.
Logged
Kari
Member
****
Posts: 83


« Reply #1 on: 24 September, 2020, 04:24:09 PM »

AFAIK no torque settings have ever been published for the Augusta engine.
I suggest the following:
Big-end bolts: +/- 25 Nm to align the nuts for the split pin.
There are no main bearing bolts. The centre support has a conical location bolt on the R/H side and is pinched by a 10 mm nut on a stud accessable throught the oil drain. Torque as by standard practice.
Rear main bearing carrier: 6 ea 10 mm studs. Again torque by standard practice, secure by tab washers.
Cylinder head bolts: for my engine I use 85 Nm working up in several steps starting at 30Nm. Tightening order x-wise starting in the middle.

I believe the club library has a translation of "Conseils Pratiques" which gives a good insight of the works on an Augusta/Belna.

Regards Karl
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Contact the Forum Administrator

LMC Forum copyright © 2007 - 2018 Lancia Motor Club Ltd

Powered by SMF 1.1.20 | SMF © 2006-2011, Simple Machines
Page created in 0.06 seconds with 22 queries.