So is the full length profile guage used to take measurements from another car? There can't be many old stock panels around any more athough the outer panels are perhaps the least of the worries, what with the fabrication and fitting in the less visible areas. I see the radiator fan cowl is perhaps available from the Netherlands, but not sure where. I will check my drain holes, which are normally hidden by the sill trims it seems. So a lot of useful information in the thread. An £80,000+ job at commercial rates? Anyhow does anyone know what the tube which runs the lenth of the sill is (page two)?
Hi Richard
I think the profile gauge was to take measurement from one side to the other.
The tube he refers to as being for the wiring loom, depending on RHD or LHD maybe only one or other is used is what I understood.
Peter