Lancia Motor Club

Model Technical and Interest => Delta and Prisma => Topic started by: lancialulu on 16 July, 2014, 11:22:02 AM



Title: Delta 1.6 i.e. idling problem
Post by: lancialulu on 16 July, 2014, 11:22:02 AM
Anyone know about the Delta bosch i.e. system?

My car starts and idles from cold fine. However, it stalls every time it comes off revs (so when it comes to a junction). Restarts fine and idles although it hunts between 500 and1200 before settling to c1000 ( on the rev counter).

When hot or cold it does the same thing. It also runs fine when not at idle.

Before I try looking at all the sensors can anyone suggest anything?


Title: Re: Delta 1.6 i.e. idling problem
Post by: fay66 on 16 July, 2014, 05:19:33 PM
Anyone know about the Delta bosch i.e. system?

My car starts and idles from cold fine. However, it stalls every time it comes off revs (so when it comes to a junction). Restarts fine and idles although it hunts between 500 and1200 before settling to c1000 ( on the rev counter).

When hot or cold it does the same thing. It also runs fine when not at idle.

Before I try looking at all the sensors can anyone suggest anything?

Tim,
Try cleaning the idle control Valve, and the throttle switch that attaches to the butterfly at the intake, as they tend to get gummed up with petrol deposits.

Brian
8227 8)


Title: Re: Delta 1.6 i.e. idling problem
Post by: SanRemo78 on 16 July, 2014, 06:35:55 PM
Try the connections on the temperature sender, these can sometimes cause an erratic idle.

Guy


Title: Re: Delta 1.6 i.e. idling problem
Post by: lancialulu on 17 July, 2014, 07:37:35 AM
Ta for thoughts.

Seems the throttle position sensor is sensitive to "throttle closed" position for something to create a "soft tickover point" in the ecu. The TPS on my car had worked loose and by trial and error I think I have found the correct setting. Time will tell.


Title: Re: Delta 1.6 i.e. idling problem
Post by: lancialulu on 23 July, 2014, 07:02:30 AM
After a number of attempts to get a stable tick over it seems that the Trottle Position Sensor (TPS) which is a quite large potentiometer fitted to the throttle spindle is worn and does not give reliable results at the zero to 100ohm part of its operation.

I am putting a call out for anyone who may have a replacement they could sell me. It is a Weber PF09.

Also has anyone had experience of fitting an Intermoter replacement?


Title: Re: Delta 1.6 i.e. idling problem
Post by: rogerelias on 23 July, 2014, 11:28:32 AM
See note under spares required :)