Lancia Motor Club

Model Technical and Interest => Flavia => Topic started by: msh2908 on 17 May, 2021, 01:53:34 PM



Title: 1970 Flavia Coupe 2000 - Clutch
Post by: msh2908 on 17 May, 2021, 01:53:34 PM
Hi everyone,

My clutch friction plate needs replaced, so I was wondering if this can be done by removing the gear box from underneath.  I suspect this is the case, but would appreciate the views from those more knowledgeable.

With thanks.

Mark


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: lancialulu on 17 May, 2021, 04:08:43 PM
That is probably the best way. If you do not have a ramp then you will need very tall /large axle stands a trolley jack with a transmission cradle. Depending on the type of gear box you may well need to remover the remote shift before dropping the box... Allow at least 2 days to get the box out and 2 to put back.


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: alan284flavia on 21 May, 2021, 04:21:04 PM
Was also pondering the same question. I have a better gearbox to install and should do the clutch, mine is on 60000 miles and has pretty long travel. Can anyone confirm the clutch diameter, I have had one supposedly listed for Flavia 2000 but would like to be certain


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: lancialulu on 22 May, 2021, 07:49:41 AM
Was also pondering the same question. I have a better gearbox to install and should do the clutch, mine is on 60000 miles and has pretty long travel. Can anyone confirm the clutch diameter, I have had one supposedly listed for Flavia 2000 but would like to be certain
exactly what Flavia?? Chassis number ?


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: alan284flavia on 30 May, 2021, 07:51:46 AM
It is the short run model Flavia 2000 with what is called the big 4 speed gearbox. Ran from 1969 to early 1971 when Flavia name was dropped. Do not have chassis no to hand


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: lancialulu on 30 May, 2021, 09:01:58 AM
It is possible that it is 215mm as later 2000 five speed


Title: Re: 1970 Flavia Coupe 2000 - Clutch
Post by: Brian Long on 25 June, 2021, 06:34:38 AM
...and I think from memory that the plate is installed 'back-to-front'. Check orientation of existing plate when you remove it.
Brian